-
The Connection of Ethernet-CANopen slave converter_GCAN
The GCAN-302 converter uses a 24V DC power supply. By using the "TCP-CANopen Config" software, the GCAN-302 converter can configure the working model and the parameter. GCAN-302 only supports communication between TCP to CANopen, other proto
-
Introduction of Ethernet-CANopen slave converter_GCAN
The GCAN-302 is a CANopen slave and Ethernet converter. The CAN side of the GCAN-302 integrates the CANopen slave protocol. The GCAN-302 converts the CANopen slave protocol signal to the Ethernet signal or converts the Ethernet signal to the
-
Node ID and CAN-Bus baud rate setting
3. Node ID and CAN-Bus baud rate setting GCAN - 301 can use "serial debugging assistant" to change the CAN bus node ID and baud rate. The instructions are shown in table 3.1, the baud rate index is shown in table 3.2. After entering the "s
-
Introduction of CANopen-RS485 converter_GCAN
GCAN-301(CANopen-RS485) has one standard CAN-Bus interface and one standard RS485 interface , it can realize the RS485 equipment as CANopen slave station access to CANopen network. It's a custom product.
-
Use Of Customized CAN bus converter with CPCI port_GCAN
GCAN-212 can use computer software to configure the basic operation parameters, such as CAN bus baud rate, CANopen node ID, Ethernet IP address, gateway and so on.
-
Introduction of Customized CAN bus converter with CPCI port
GCAN-212 is a customized converter with one or two CAN bus interfaces. The converter has integrated CPCI interface, so it can be used to IPC which communicate through CPCI bus. The GCAN-212 can customize multiple communication interfaces su
-
Company Links：
